D.I.Y. INSTRUCTIONS

• CONTENTS OF KIT.
  
  4 X COLUMNS (POLES)
  4 X HOOPS
  1 X CENTRE CROSS
  1 X SHADE NET (22 METRES. GALVANISED STEEL CABLE INSIDE NET)
  2 X CLAMPS
  8 SCREWS
  
• CHOOSE THE AREA WHERE YOUR CARPORT IS TO BE ERECTED.
  SPREAD THE NET OPEN AND MEASURE THE NET SIZE TO BE SURE THAT WHEN YOU
  PLANT THE POLES, THEY ARE +/- 50mm APART TO THE SIZE OF THE NET.
  E.G. IF THE NET MEASURES 4.9M X 5.4M THE POLES MUST MEASURE 5M X 5.5M.
  THIS WILL ENABLE THE NET TO BE PULLED TIGHT OVER THE HOOPS.
  
• PLANT THE POLES 400 X 400 X 400MM DEEP IN CONCRETE. LEVEL THE UPRIGHTS
  WITH A SPIRIT LEVEL. LET THE CONCRETE SET FOR +/- 24 HOURS.
  
• PLACE THE SHORT END OF THE ONE HOOP OVER THE UPRIGHT CAP (START ANY SIDE).
  INSERT THE CROSS INTO THE FIRST HOOP. INSERT 2ND HOOP INTO CROSS (IN LINE
  WITH THE 1ST), THEN ONTO THE CAP. REPEAT FOR THE OTHER TWO HOOPS, SO
  THAT ALL FOUR HOOPS ARE ON THE UPRIGHTS AND IN THE CROSS.
  
• DRILL 4MM HOLES AT EACH END OF THE JOINS AND FASTEN WITH THE SCREWS,
  (OR RIVETS).
  
• HOOK THE NET OVER THE HOOPS ON THE ONE SIDE AND ATTACH A ROPE TO THE
  REMAINING TWO CORNERS. PULL THE NET OVER THE TOP OF THE HOOPS AND
  PULL INTO PLACE.
  
• MAKE SURE THE ROPE IS HOOKED UNDER THE PINS AFTER YOU HAVE PLACED THE NET
  IN POSITION.
  
• PULL THE ROPE AS TIGHT AS POSSIBLE. PLACE THE TWO CLAMPS AS CLOSE TO THE
  POLES AS POSSIBLE AROUND THE ROPE.

THE PLANTING OF COLUMNS

PLOTTING THE AREA OUT AS PER EXAMPLES
(ALL SIZES ARE MEASURED ON THE SAME PRINCIPLE)

SIZE: DIAGONALS:

3.0 X 5.0 5.830
5.0 X 5.0 7.070
7.0 X 5.0 8.600